Fermacell Greenline Floor Glue 1kg

The fermacell® greenline Floor Glue is a label-free, non-foaming, dispersion based, single-component adhesive, which hardens through the evaporation of water viscoplastic.

Features:

• Easy to apply - the special twin nozzles ensure that the correct amount of glue and placement on the joint edge.
• As an alternative to fermacell® Floor Glue, greenline Flue Glue may be used.

Technical data:

• Weight - 1kg
• Size - 1kg
• Brand - Fermacell

Application:

• Two glue strings are applied to the rebated edge of the fermacell® Flooring Elements.
• The glue is applied in a single application due to the twin nozzles at the top of the bottle.

Suitable for the following areas:

• For gluing rebated edges (in the home (AA 1) and in offices (AA 2)).
• For complete gluing of a third layer of fermacell® Gypsum Fibreboards on flooring elements.
• In wet rooms with humidity exposure class A0 (pursuant to ZDB and IGG leaflet).

Characteristics:

• Label-free, low in harmful substances and low-emission (tested by ECO Institute Cologne)
• Free of isocyanate, softeners, silicone and solvents (pursuant to TRGS 610)

Installation:

• Shake fermacell® greenline Floor Glue before use.
• The rebated edges of the fermacell® Flooring Elements are glued with fermacell® greenline Floor Glue.
• Two glue strings (diameter approx. 5mm) are applied to the edges for this purpose.
• This takes place in a single step due to the special twin nozzles.
• The next element should be fitted and glued in the perimeter area within 10 minutes, so that the glue fully fills and oozes out of the joint.
• This serves to ensure the complete wetting/penetration of the glue to the butt-joints.
• In order to ensure the necessary contact pressure, one’s own body weight is applied to the upper fermacell® Flooring Element and it is then screwed with fermacell® screws or stapled to the lower element with special diverging staples.
• The maximum adhesive joint width is 2mm.
• After approx. 5-30 minutes, the excess glue should be removed with a fermacell® glue scraper, a spatula or a chisel.
• The surface should then not be walked-on for the next 24 hours.
• Hardened glue (>24 hours dry) can be removed with a fermacell® glue scraper or chisel.
• The laid surface can be walked-on after approx. 24 hours at a normal indoor climate of 20°C and 50% humidity.
• After approx. 72 hours, the full load-bearing capacity is achieved

Screws:

• 200mm centres for the flooring elements (fermacell® screws for fermacell® flooring Elements)
• 150mm centres for Powerpanel H2O Flooring Element (fermacell® Powerpanel H2O floor screws)

Special diverging staples:

• 150mm centres for fermacell® Gypsum Fibre or Powerpanel H2O Flooring Element

Please notes:

• Remove excess glue after 5-30 minutes with a scraper.
• Do not walk on the surface for 24hrs.
• Leave to cure for this time at an ambient indoor climate of 20°C and 50% RH.
• Remove any hardened glue.
• After 73 hours the full load bearing capacity of the flooring element joints are achieved.